Hi,
while doing tutorial 1 in “sketch using line and arc” i was trying to modify dimension as shown in attached figure to" 2.25"
Thank you
Hi,
while doing tutorial 1 in “sketch using line and arc” i was trying to modify dimension as shown in attached figure to" 2.25"
Hey,
you have might used the wrong method for creating the ARC. try another method.
Hello, Musmanqureshi77 , As I see your sketch you’r trying to over define your sketch so this hapeen. you already give arc radius so you can not give distance between tow lines.
Hope this is use ful for you
Thank you
Hi there,
Hope this issue is resolved.
Keep learning.